nnce
BD310
BD310 Display function inside the device
Safety Precautions and Warnings
To avoid injury or damage to the vehicle and/or scan tool, first read this
manual and observe the following safety precautions when working on
a vehicle:
• First, turn off the ignition. Connect the 16-pin connector, and then turn on
the ignition
• Always perform vehicle tests in a safe environment.
• Do not attempt to operate or observe the unit while driving a vehicle
• Operating or observing the device is distracting to the driver and can result
in a fatal accident.
• Wear safety glasses that meet the standards of ANSI.
• Keep clothing, hair, hands, tools, test equipment, etc. away from all moving
or hot engine parts
• Operate the vehicle in a well-ventilated area: Exhaust fumes are toxic.
• Place blocks in front of the drive wheels and never leave the vehicle
unattended while performing tests.
• Use extreme caution when working near the ignition coil, distributor cap,
ignition wires and spark plugs. These components generate dangerous
voltages when the engine is running
• Have a fire extinguisher nearby that is suitable for gasoline, chemical, and
electrical fires
• Keep the scan tool dry, clean, and free of oil/water or grease. If necessary,
use a mild detergent on a clean cloth to clean the outside of the scan too
— OBD ,'EOBD+CAN
To Next Page
Loading...
