Ance
BD310
According to the above figure to press ENTER and the screen will display
the interface as shown on the next page:
Emission-Related
Diagnostic
Information has
been Cleared!
Annotations:
Before performing this function, be sure to retrieve and record the error
codes.
After clearing, you should retrieve the fault codes again or turn on the ignition
and retrieve the codes again If there are still error codes in the system,
please troubleshoot the codes by using factory diagnostic manual, then clear
the codes and check them again.
3. 11M Readiness
Press the UP / DOWN button to select 11MReadiness and press ENTER. The
screen will display the interface as shown below:
Diagnostic Men
Read Codes
Erase Codes
11MReadiness
Data Stream
Freeze Frame
Evap System Test
Vehicle Information
24
11MReadiness
Since DTCs Were Cleared
This Drive Cycle
OBDI /EOBD+CAN —
To Next Page
Loading...
