BST100 MANUAL
5-3-2.
Press <▲> <▼> to select “3. Charging Test”.
5-3-3.
Press <ENTER> to conduct RIPPLE TEST.
5-3-4.
Press “ENTER” again, or wait for a few seconds for “Charging Test”. Right now turn off all electric
systems and press vehicle accelerator to increase RPM to 2500r/min and maintain 2500 r/min for 5
seconds, which will be display in the screen.
5-3-5.
Press “ENTER” to display the test result as below. Press <ESC> to return to main menu.
Charging Test Result Instruction
Reference Table (For 12V System)
To Next Page
Loading...
