indicates "No (pending) codes are stored in the module!" Wait a
few seconds or press any key to return to the Diagnostic Menu.
2) View DTCs and their definitions on screen.
DTC
p0143
Generic
1/8
Current
02 Sensor Circuit Low Voltage
Bank 1 Sensor 3
ESC
The control module number, sequence of the DTCs, total number
of codes detected and type of codes (Generic of Manufacturer
specific) will be observed on the upper right hand
corner of the display.
5.2 Erase Codes
Notes: This function is performed with key on engine off. Do not
start the engine. Before performing this function, make sure to
retrieve and record the trouble codes. After clearing, you should
retrieve trouble codes once more or turn ignition on and retrieve
codes again. If there is still some trouble codes for hard troubles,
please find the reason caused the trouble code firstly, and then
solve the problem. Now, the trouble codes can be erased.
1) Use the UP/DOWN scroll buttons to select Erase Codes from
the Diagnostic Menu and press [0K].
Diagnostic Menu
Read Codes
Erase Codes
I/M Readiness
Data Stream
Eva S stem Test
Vehicle Information
1/6
19
To Next Page
Loading...
