OPERATION INSTRUCTIONS
1. Connect VD700
1.1 Turn the ignition on.
1.2 Locate the vehicle's 16-pin Data Link Connector (DLC).
2. VD700 Features
2.1 For VW
Choose [For VW ] and then select [Vehicle Scan]. As follows:
Select Menu
Vehicle Scan
System Selection
Crafter LT3 2006-2017
S ecial Functions
1/4
Select Menu
System Scan
Manual Select
1/2
Remark: [ System Scan] is used to check faulty systems and
display the number of faults
[ Manual Select ] uses to scan all supported systems.
Select System
0017-Dash Board
0019-Gateway
0061-Batter Re ulation
5
5
1
1/3
To Next Page
Loading...
