Anchor AN-1000X+ Quick Start Manual

For a complete Owner’s Manual, visit anchoraudio.com
Please check your new unit carefully for any damage which
may have occurred during shipment.
*Please keep the product box(es) that your Anchor Audio product(s) was
shipped in, so it is available in the event the product(s) need to be shipped
back to Anchor Audio for any reason.
AN-1000X+ | AN-30 | AN-MINI
QUICK START MANUAL
MOUNTING THE SPEAKER MONITORS
NEED MORE HELP?
anchoraudio.com | 800.262.4671 | techsupport@anchoraudio.com
RECOMMENDED BRACKET
AN-1000X+
SB-3BK+, SB-360BK+,
RM1BK+, or RM12BK+
AN-30 SB-30
1. Attach mounting bracket securely to the wall/ceiling with pre-
drilled holes.
2. Remove Allen head cap screws from the bracket mounts on
the unit.
3. Align the bracket arm with mounting hole on unit.
4. Attach both sides of the speaker securely to mounting bracket.
HAVING TROUBLE WITH YOUR SOUND SYSTEM?
CONDITION POSSIBLE SOLUTIONS
No Sound (Power LED: OFF)
• Turn POWER knob clockwise to turn ON
• Check battery level, charge battery, or plug in AC cord
No Sound (Power LED: ON)
• Check your source audio and turn up volume of source audio
• Make sure all cables are completely plugged in
• Turn up volume control
Wireless Mic will not Connect to
System
• Check battery level of microphone
• Un-pair all microphones from the system then re-pair the
microphones
Connected Wireless Mic but No Sound
(Solid Green LED)
• Check the Mute button on the microphone or belt pack
• Raise volume on the microphone and system
• Check battery level of microphone and system
Poor Wireless Range /
Poor Wireless Audio Quality
• Check battery level of microphone and system
• Re-position system away from any possible interference
sources
• Minimize obstructions between the system and wireless
microphone
• If wireless range continues to be poor, call Anchor Audio Tech
Support
Distorted Sound
• Check battery level, charge battery, or plug in AC cord
• Lower system volume
• Lower source audio volume
• Wireless belt pack - ensure Mic and/or Line Level setting is
correct
Excessive Feedback (Squelching)
• Lower the volume on the microphone (handheld or belt pack)
• Do not stand within at least 10 feet in front of the speaker
with the mic(s)
Excessive Hum or Noise
• Use shielded cables
• Use a balanced microphone

Anchor AN-1000X+ Specifications

Power

rated power output	50 watts continuous @ 4W
AC power requirements	110 – 125Vac, 50/60 Hz, 90W
export model AC power requirements	208 – 240Vac, 50/60 Hz, 90W

Audio

max SPL @ rated power	107 dB @ 1 meter
frequency response	65 Hz – 20 kHz ± 3 dB
speaker type	4.5” woofer with shielded magnet
tweeter type	10mm dome tweeter

Tone Controls

bass control range	+8 – 12 dB @ 100 Hz
treble control range	+10 – 12 dB @ 10 kHz

Weight and Dimensions

height	5.25 inches
width	8.4 inches
depth	9 inches
dimensions	13 x 21 x 23 cm
weight	9.5 lbs, 4.3 kg