Battery Replacement
1. Low Battery Power Alert
When the battery power is low,
the electronic filter monitor
generates an audible sound and a
battery symbol blinks on the top
right corner of the LCD. When this
2. Last data Automatically Memorized
The Anchor DigiPure 9000s is operated by 2 AAA alkaline
batteries. The batteries last more than a year. When not in use,
LCD automatically turns off in 3 seconds to save battery power
after displaying the remaining capacity. The last data displayed
is automatically memorized after the display turns off.
3. Reset after replacing filter cartridge
After the filter cartridge is replaced, press the ‘Reset’ button on
the unit to reset the remaining capacity of the filter to default
value.
happens, replace the batteries. After the batteries are replaced,
the sound and blinking will stop.
For resetting monitoring
capacity when the remaining
capacity shown is not 0, press
and hold the ‘Display’ button
and then press ‘Reset’. The LCD
will blink for 10 seconds and
then stop. This will reset the
capacity.
To Next Page
Loading...