How to exchange the
ት- shaped part in a breakage
1.
See pictute
Cut cable tie with scissors
2.
See pictute ②
Using an I head screwdriver,
remove a tighten-up E-ring to prevent the
ት-shaped part and from sliding off.
3.
See pictute ⊙
After removing the E-ring,
remove the broken ት- shaped part and
grease a new ት- shaped part and fasten it.
4.
See pictute ④
Put a cable tie right to left under
the ት- shaped part, tight it up appropriately and
finish at a forty-five angle.
¥To tighten up only with a cable tie can prevent
the ት-shaped part from sliding off without fastening
an E-ring. Another cable tie tightening will make it
easier to prevent the part from sliding off.
[14]
To Next Page
