1
Instructional images show Traditional Handle Set, follow the same procedure for Modern Handle Set.
Andersen Storm Door Division is a wholly owned subsidiary of Andersen Corporation. Andersen Storm Door Division manufactures and supports the limited warran-
ties for Andersen® and EMCO® storm doors. “Andersen” and “EMCO” and all other marks where denoted are trademarks of Andersen Corporation. ©2020 Andersen
Corporation. All rights reserved.
12-2020 r4 18011 Print in Color
PARTS OVERVIEW
P/N 618803
Improper use of hand or power tools could result in injury and/or product
damage. Follow equipment manufacturer’s instructions for safe operation.
Always wear safety glasses.
RECOMMENDED TOOLS
Handle Installation Guide
Please do not return product to store.
Contact the Storm Door Solution Center at 1-800-933-3626 with
any questions regarding installation, lost part replacement, or
anything related to your purchase.
Exterior Trim Plate
Interior Trim Plate
Handle without Spindle
Handle with Spindle
Lock Case Trim Plate
Dead Bolt Key Cylinder
1 1/2" Pan head Screw x2
1 1/2" Flathead Screw
#10 x 5/8" Screw
Safety Glasses
Screwdriver
!
!
1/2”
1/2”
1/2”
1”
1 1/2”
2”
1 1/2”
5/8”
5/8”
Your storm door lock can be re-keyed to match your main door’s handle set if it’s a Kwikset® (included) or a Schlage® (additional purchase required). Many home
improvement stores or locksmiths can make duplicate keys.
“Kwikset” is a registered trademark of Newfry LLC. “Schlage” is a registered trademark of Schlage Lock Company.
Thank you for choosing Andersen.
Scan to Access
Support Video
SAFETY FIRST: PLEASE READ AND FOLLOW ALL CAUTIONS AND WARNINGS IN THIS GUIDE.
Read this entire guide before you begin. If your abilities do not match the requirements of this installation, contact an experienced contractor.
Entry door hardware and handle may
become hot when exposed to sunlight.
CAUTION
WARNING
A
B
C
D
E
A
I
F
G
H
A
B
C
D
E
F
G
I
G
H
To Next Page
Need help?
General
