7English
Charging the headphone:
´ Use the Micro USB cable and connect head-
phones to you computer or adaptor device
made for USB charging.
´ A red LED indicator will turn on when the head-
phones are charging. The red LED light will turn
off when headphones are fully charged.
Bluetooth-pairing:
1. Turn on the headphones and place them close
to the Bluetooth activated unit you wish to pair
with.
2. Press and hold button for 6 seconds to
activate the pairing mode, the LED indicator will
quick flash in red and blue.
3. Note: If no Bluetooth unit is found - the head-
phones will enter waiting mode and eventually
turn off after 5 minutes.
4. Select ANC 1.0 from the list of discovered Blue-
tooth units and enter password 0000, if needed.
5. When pairing is successful, the LED indicator
will lit in blue.
6. For future use - the headphones will be automat-
ically paired with the previously paired Bluetooth
unit when they are turned on.
Cable connection:
´ Connect a 3.5 mm audio cable to the 3.5 mm
input on the headphones and then to an audio
unit. Telephone functions are disabled when
using cable connection.
Operation
To Next Page
Loading...