7
Operation
Before first use:
´ Remove all of the packaging from your coffee maker and place
it on a flat surface.
´ Brew only water for a couple of times to make sure the coffee
maker is clean and ready to brew coffee:
1. Open the top cover and fill the water tank with cold water.
Note: Do not fill the water tank with water that exceeds the
maximum level indicated on the water gauge.
2. Close the top cover and connect the power plug to a wall
outlet. Press the “On/Off” button to start brewing.
3. Repeat step 1-2 for two to three times.
Get started:
1. Open the top cover and fill the water tank with cold water.
Note: Do not fill the water tank with water that exceeds the
maximum level indicated on the water gauge.
2. Open the funnel cover and place the filter in the funnel.
3. Add coffee powder into filter.
4. Insert the carafe with lid in place onto the warming plate.
5. Plug the power cord into a wall outlet.
6. Press the “ON/OFF” button to start the appliance, the power
indicator will start illuminating red. The appliance will begin
working. Press the “ON/OFF” button again to stop the appliance
from brewing.
7. After brewing, the appliance will automatically switch to keep
warm mode. The appliance will shut off automatically after 40
minutes from the ON/OFF button being activated.
8. When the coffee is done, you can temporarily remove the carafe
to pour and serve hot coffee. The brewing cycle will not be
interrupted and no coffee will drip from the appliance, simply
replace the carafe onto the warming plate to restart the brewing
cycle.
Note: Do not remove the carafe for longer than 30 seconds and
never put an empty carafe onto the warming plate when it is still
warm.
Note: The appliance will shut off automatically after 40 minutes
from the ON/OFF button being activated.
To Next Page
Loading...