English 10
Loading the salt into the softener
1. Remove the basket and unscrew the reservoir cap.
2. Place the end of the funnel (supplied) into the hole and
pour in about 1.5kg of dishwasher salt.
3. Fill the salt container to its maximum limitwith water, It is
normal for a small amount of water to come out of the salt
container.
4. After filling the container, screw back the cap tightly.
5. Replace the basket and immediately start the dishwasher
after filling the salt into the salt container at the first time.
Note: We suggest to use a short program, otherwise
the filter system, pump or other important parts of the
machine may be damaged by salty water. This is out of
warranty.
Note: The salt container must only be refilled when
the salt warning light “ ” in the control panel comes
on. Depending on how well the salt dissolves, the
salt warning light may still be on even though the salt
container is filled.
Note: If salt has spilled, run quick program to remove it.
Adjusting salt consumption
1. Press the Start/pause button for more than 5 seconds to
start the water softener set model within 60 seconds after
the appliance was switched on.
2. Press the Start/Pause button to select the proper set
according to your local environment, the sets will change
in the following sequence:
H1->H2->H3->H4->H5->H6
3. Without any operation in five seconds, the machine will
exit from set mode, the machine is into standby status.
Water hardness
Setting on the
water softener
Digital display
stalls
o
dH Mmol/l
0 - 5 0 - 0.9 1 H1
6 - 11 1.0 - 2.0 2 H2
12 - 17 2.1 - 3.0 3 H3
18 - 22 3.1 - 4.0 4* H4
23 - 34 4.1 - 6.1 5 H5
35 - 45 6.2 - 8.0 6 H6
* factory setting
o
dH: German degree of measurement for the water hardness
Mmol/l: millimol, internationel unit for water hardness
Operation
To Next Page
Loading...