11English
Filling The Rinse Aid Reservoir and Detergent Dispenser
1. To open the dispenser, turn the cap to the “open” (left)
arrow and lift it out.
2. Carefully pour in the rinse-aid into its dispenser, whilst
avoiding it to overflow.
Note: Clean up any spilled rinse aid with an absorbent
cloth to avoid excessive foaming during the next wash.
3. Replace the cap by inserting it aligned with “open” arrow
and turning it to the closed (right) arrow.
4. Lift out the cup to adjusting the rinse aid
reservoir. Both the recommended setting and
default setting is “4”. Higher for dirtier tableware.
5. Press the release catch on the detergent 2 dispenser to
open the cover.
6. Add detergent into the larger cavity (A) for the main wash
cycle. For more heavily soiled wash loads, add some
detergent into the smaller cavity (B) for pre-wash cycle.
7. Close the cover and press on it until it locks into place.
8. When the rinse-aid container is full, the indicator will be
fully dark. As the rinse aid diminishes, the size of the black
dot on the rinse aid level indicator changes, as illustrated
below. You should add detergent into
the container when
rinse aid level is less than 1/4 full.
Operation
To Next Page
Loading...