9English
Before first use:
Installing the dishwasher
1. Insert the drain hose into a drain pipe with a minimum
diameter of 4 cm, or let it run into the sink, making sure
to avoid bending or crimping it. The height of drain pipe
must be less than 600mm. The free end of the hose must
not be immersed in water to avoid the back flow of it.
Note: Please securely fix the drain hose in either position
A or position B.
Note: If you need a drain hose extension, make sure to
use a similar drain hose.
It must be no longer than 4 metres; otherwise the
cleaning effect of the dishwasher could be reduced
Warning: Disconnect electrical power before installing
dishwasher.
Failure to do so could result in death or electrical shock.
2. Connect the cold water supply hose
to a threaded 3/4(inch) connector and
make sure that it is fastened tightly in
place.
Note: If the water pipes are new or
have not been used for an
extended period of time, let
the water run to make sure
that the water is clear. This
precaution is needed to
avoid the risk of the water
inlet to be blocked and
damage the appliance.
Warning: A hose that attaches to a sink spray can burst
if it is installed on the same water line as the dishwasher.
If your sink has one, it is recommended thet the hose be
disconnected and the hole plugged.
Operation
To Next Page
Loading...