Andis Blade Zero Gapper User Manual

USE AND CARE
Andis Blade
Zero Gapper
For Outliner
®
& Styliner
®
Blades
#04521, #04604, #26704, #32859
Congratulations—you just went first class when you bought this
Andis appliance. Careful workmanship and quality design
have been hallmarks of Andis products since 1922.
KEEP THIS FOR YOUR RECORDS
Andis Company
1800 Renaissance Blvd. Sturtevant, WI 53177
1-800-558-9441 Canada: 1-800-335-4093
info@andisco.com www.andis.com
©2013 Andis Company, U.S.A.Form #04762 Printed in Taiwan
7
9
8
6
Release the blade lock by pressing the button on the
left side of the locking arm. The button should click
into place.
Remove blade assembly by pushing down on the front
of the blade.
Turn screws to the right to tighten. Pull the upper blade adjustment bracket back to release
the blade set. Your blade set is now zero-gapped.
Requires only a screwdriver to adjust blade.
Phillips for Outliner
®
and T-Outliner
®
;
flathead and phillips for Styliner
®

Andis Blade Zero Gapper Specifications

General

Brand	Andis
Model	Blade Zero Gapper
Category	Personal Care Products
Language	English

Summary

Andis Blade Zero Gapper Use and Care

Loosen Blade Adjustment Screws

Turn screws left to loosen for Outliner or Styliner blades, cautioning against over-loosening.

Attach Blade Assembly to Gapper

Place blade assembly holes onto gapper pins and lift front of blade to click into place.

Verify Blade Seating

Ensure the blade is properly seated against the lip of the blade gapper.

Adjust Upper Blade Bracket

Push upper blade adjustment bracket forward until upper blade is firm against angled metal.

Lock Blade Assembly

Press button on right of locking arm to lock blade assembly into place.

Zero-Gap Blade Set

Pull upper blade adjustment bracket back to release blade set for zero-gapping.

Remove Blade Assembly

Push down on the front of the blade to remove the blade assembly.