8
CARE AND SERVICING OF YOUR ANDIS CLIPPER BLADES
The blades should be oiled before, during, and after each use. If your clipper blades
leave streaks or slow down, it’s a sure sign that the blades need oil. The clipper
should be held in the position shown in Figure K to prevent oil from getting into
the motor. Place a few drops of Andis Clipper Oil on the front and side of the cutter
blades (Figure L). Wipe excess oil off the blades with a soft dry cloth. Spray lubricants
contain insufficient oil for good lubrication, but are an excellent clipper coolant.
Discontinue use of broken or nicked blades to prevent injury. You can clean the
excess hair from your blades by using a small brush or an old toothbrush. To clean
the blades we suggest immersing the blades only into a shallow pan of Andis Blade
Care Plus while the clipper is running. Any excess hair and dirt that has accumulated
between the blades should come out. After cleaning, turn your clipper off, dry the
blades with a soft, dry cloth and start clipping again.
BLADE & CLIPPER REPAIR SERVICE
When the blades of your Andis clipper become dull after repeated use, it is advised
to purchase a new set of blades available through your Andis supplier or through an
Andis authorized service station. Some blade sets can be resharpened – contact
Andis Company for information on resharpening. If you wish your clipper to be
serviced as well, it should be carefully packed and mailed either Parcel Post Insured,
or U.P.S. to any Andis authorized service station. To contact Andis directly, please
call our Customer Support Team at 1-800-558-9441 or email us at
support@andisco.com.
CAUTION: Never handle your Andis clipper while you are operating a water
faucet, and never hold your clipper under a water faucet or in water. There is
danger of electrical shock and damage to your clipper. Andis Company will not
be responsible in case of injury due to this carelessness.
To Next Page
Loading...
