Continuum I/O System Reference
5
Wiring to controlled points or sensors is accomplished via a standard removable screw
terminal block located at the bottom of the module behind the door. An open area at the
bottom of the case allows wires to exit in an appropriate manner.
On the back of each module are molded DIN rail guide fingers. The design allows the
module to easily hook onto and slide along a standard DIN rail.
With the mounting brackets extended outward, hook the module onto the DIN rail as
shown below:
Locking Fingers
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...