Continuum I/O System Reference
105
Relays
The GE relays are mounted on an external bracket with integral connecting cable. This
cable terminates in a five-pin Molex-style connector that mates easily with one of the two
provided at the bottom of the module as shown below:
The connector is keyed so that it locks into place after insertion. The connector on the left
is output relay #1 and the one on the right is output relay #2. Lights are attached to the
relays by loosening the screw terminal on the top of the relay, inserting the stripped end
of the wire, and tightening the screw.
LO-2
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...