86
Andover Controls
Output Circuitry
The following is a simplified schematic of each DO-4-R Output channel:
All 4 channels resemble the circuit shown above.
These output contacts operate as a standard relay. When the output is set to an ‘ON’
state, the normally open contacts (OUTx NO) close and the normally closed contacts
(OUTx NC) open.
To use the Form C output in your system, configure an output point with an Electrical
Type of
Digital
.
OUT x NC
OUT x NO
OUT x COM
DO-4-R
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...