andover SPINSTAND - Anti-Tip Kit

Anti-Tip Kit installation
IMPORTANT NOTE: An Anti-Tip Strap is
included with your Spinstand . Please use it
whenever Spinstand is installed in a location
where it may tip and cause physical harm .
Drywall inserts {Item 23) and screws {Item
22) are included with this kit, but may not
be suitable for every type of wall. It is your
responsibility to supply wall mounting
hardware suitable for the specific wall con-
struction of your home. It is best to l ocate
the Spinstand such that the Anti - Tip bracket
may be screwed directly into a wall stud
whenever possible.
1. Once Spinstand is in position, locate
the second Bracket (Item 20} at the
approximate height of the top shelf and
centered relative to the stand. Mark the
location of the two screw holes with a
pencil.
2. Drill suitable pilot holes for your pre-
ferred wall anchors at the marked posi-
tions . If you use the anchors we supply,
use 1/4" drill bit. Install the anchors and
attach the remaining bracket. Anchors
are not needed if the bracket can be
attached to a stud. An 1 /8" drill should
be used for pilot holes in a stud.
3. Loop the Anti-Tip strap {Item 24}
through both brackets and insert the tip
of the strap through the latching end,
forming a closed loop. Check to make
sure the latch is secure and will not slip
open.
Page 10