To Next PageTo Next Page
Need help?Do you have a question about the Andrew 3.7-Meter Earth Station Antenna and is the answer not in the manual?
General| Antenna Size/Diameter | 3.7 meters |
|---|---|
| Mount Type | Elevation over Azimuth |
| Material | Aluminum |
| Frequency Range | C-band, Ku-band |
| Polarization | Linear and Circular |
| Wind Survival | 200 km/h |
Contact information and procedures for obtaining technical support for the antenna.
Provides preliminary information, warnings, and checklists for installation.
Details the step-by-step process for assembling the antenna components.
Explains how to operate the antenna and acquire a satellite.
Outlines procedures for inspection, cleaning, and upkeep of the antenna.
Lists critical safety warnings for installation and operation of the antenna.
Lists essential tools required for the proper installation of the antenna.
Procedures for checking shipment, reporting loss/damage, and inventory.
A checklist to verify and determine the correct installation sequence.
Instructions for unpacking and assembling the main reflector halves of the antenna.
Guides on preparing the ground mount foundation according to specifications.
Details the proper tensioning of A-325 hardware to ensure secure connections.
Procedures for installing the ground mount assembly, including manual and crane options.
Installation steps specific to the embedded pipe ground mount configuration.
Instructions for unpacking, assembling, and testing the reflector.
Steps for attaching the enclosure to the reflector for weather protection.
Procedures for installing the assembled reflector onto the ground mount.
Steps for assembling and adjusting the subreflector for optimal performance.
Final phase of installation covering the feed system and optional components.
Steps to manually position the antenna and acquire a satellite signal.
Procedure for removing the manual actuator after antenna adjustments.
Procedures for adjusting the subreflector to maximize antenna performance.
Guidelines for cleaning the equipment and inspecting electrical parts.
Procedures for inspecting mechanical parts and the control system.
Procedures for checking voltage and current readings of antenna drive motors.
Guidelines for lubricating parts and preserving component surfaces.
Inspection and lubrication procedures for jackscrew and motor assemblies.
