Andrew ATC200-Lite Teletilt

Need help?

Do you have a question about the Andrew ATC200-Lite Teletilt and is the answer not in the manual?

Summary

Section 1 Controller Setup

1.1 System Description

Overview of the ATC200-Lite control system, its components, and installation advice.

1.2 ATC200-Lite Series Controller Communication

Explains the ATC200-Lite controller's function as an interface and its communication methods.

1.3 ATC200-Lite Series Controller Setup

Step-by-step instructions for physically connecting the ATC200-Lite controller to a PC.

Section 2 Program Installation

2.1 Program Download and Installation

Guide to downloading and installing the ATC200-Lite software from the Andrew website.

2.2 Software Upgrades and Antenna Definition File Updates

Procedure for updating ATC200-Lite software and antenna definition files.

Section 3 Program Startup and Configuration

3.1 Preparing for Program Startup

Pre-startup checks and verification steps for the ATC200-Lite application.

3.2 Serial Port Selection at Program Startup

Instructions for selecting the correct serial port for PC-to-controller communication.

3.4 Antenna Definition File Selection

Process for choosing the correct antenna definition file for system configuration.

Section 4 Device Discovery and Addressing

4.1 Device Search

How to scan the RS-485 bus to find AISG devices connected to the ATC200-Lite.

4.2 Addressing

Steps for manually readdressing devices connected to the ATC200-Lite system.

Section 5 Device Configuration

Section 6 Changing the Electrical Downtilt on a Single Antenna

Section 7 Changing the Electrical Downtilt on a Group of Antennas

Section 8 Saving a Site Report or Site Configurations

8.1 Saving;Viewing a Site Report Formatted to Open in Word

How to save site configuration data as a report file for Microsoft Word.

8.2 Saving;Viewing a Site Report Formatted to Open in Excel

Method to save site configuration data as a tab-delimited file for Excel.

8.3 Saving Configurations for Future Use

Instructions for saving the current system configuration for future use.

Section 9 Device Test, Alarm Status and Device Information

9.1 Obtaining Device Information

Retrieving hardware and software versions for connected ATC200-Lite devices.

9.2 Retrieving Current Alarm Status

Process for checking and displaying current alarm status for devices.

9.3 Clearing All Alarms on a Device

Steps to clear any active alarms reported by a device.

9.4 Executing a Self Test Movement for a Device

Performing a self-test movement to verify actuator motor functionality.

Section 10 Part Numbering Scheme and Ordering Guide

10.1 Part Numbering Scheme

Explanation of the part numbering system for ATC200-Lite components.

10.2 Ordering Guide

Example guide for ordering system components based on site needs.

Section 11 Control System Specifications

Appendix A ATC200-Lite Series TELETILT System Site Configuration Worksheet

Appendix B Antennas For ATC200-Lite Series System