&Tradition DEVELIUS EV1 - Module Assembly Steps; Step 1: Prepare Module; Step 2: Attach Brackets; Step 3: Reorient Module

STEP 1
Tilt one of the modules carefully on to the back. When the sofa is standing on the back -
take notice of the pre-drilled holes in the wooden frame.
STEP 2
Place the linking brackets over the pre-drilled holes and fasten with the supplied screws
using a screwdriver.
STEP 3
When the brackets are rmly attached to the module - carefully lift the module back on
the feet again.
STEP 4
Two persons are needed for this step. Do not assemble the modules on your own.
Take the next module which is supposed to be attached to the rst module and lift it over
the brackets and carefully put the module down over the brackets from the other module.
Make sure that both modules are rmly standing on the ground.
Pre-drilled holes