To Next PageTo Next PageWhy my Anets Fryer appliance will not maintain temperature properly?
If your Anets Fryer appliance will not maintain temperature properly, it may be due to a faulty or improperly calibrated thermostat, or a faulty hi-limit switch.
Why oil/shortening does not reach desired temperature in my Anets SLG Fryer?
If the oil/shortening in your Anets Fryer does not reach the desired temperature, it could be due to a faulty or improperly calibrated thermostat.
Why do the main burners not shut off on my Anets SLG Fryer?
Inspect appliance for damage, check packing list, record model/serial number.
Appliance comes assembled, exception of legs/casters.
Instructions for attaching and leveling legs/casters for proper operation and sanitation.
Provides technical data for SLG40 and SLG100 models regarding fuel, gas, pressure, and burner specifications.
Specifies required clearances for combustible and non-combustible installations.
Guidelines for connecting the appliance to the electrical supply according to codes.
Emphasizes the need for proper ventilation and fire safety systems for safe operation.
Procedure to clean the appliance of protective oil coating before first use.
Guidelines for food quality, shortening/oil care, and load limits for optimal performance.
Step-by-step instructions for starting the appliance, including pilot ignition.
Procedures for safely shutting down the appliance, including turning off gas and thermostat.
Daily procedures for cleaning appliance exterior, surfaces, and fry tank.
Weekly thorough cleaning of the entire appliance with mild detergent.
Weekly procedure to remove food debris and oil build-up using water and cleaner.
Procedure to verify thermostat accuracy by comparing readings to appliance temperature.
Step-by-step guide to calibrate the thermostat for accurate temperature control.
Tables to diagnose common appliance faults and their possible causes.
Procedure for converting the appliance to a different gas type, including parts replacement.
Technical data tables for gas conversion, detailing model, fuel type, and orifice specifications.
General
