ANFIM Luna - Page 2

Luna | EN
Fault Cause Remedy
The grinder
is not grind-
ing fine
enough.
The grinding discs are worn
out or require readjustment.
» See Anfim Luna Service YouTube
playlist: "Burr Replacement", or
contact a service technician for
support.
The grinder
does not
grind con-
tinuously or
the grind-
ing process
stops.
The trigger switch is defec-
tive.
» Replace the switch. Contact a
service technician for support.
The grind-
er’s dis-
pensing
accuracy is
decreasing.
The spout is clogged.
T
oo much ground coffee has
been deposited in solid form
inside the grinder.
» Switch off the grinder and clean the
spout system (see instruction manual
„Cleaning the spout system“). Set the
grinder to the highest (coarsest)
setting and start the grinding process.
The grinder will clear itself. Then set
the desired grinding degree during
operation again.
The grinder spout is dam-
aged. / The flapper is
defective.
» Replace spout/flapper. See Anfim
Luna Service YouTube playlist:
"Flapper Replacement".
The bean
hopper
cannot be
inserted.
There are beans in the bean
hopper intake.
» Remove the beans from the bean
hopper intake.
The grinds
do not land
in the centre
of the por-
tafilter.
The spout is not correctly
aligned with the portafilter.
» Align the spout centrally with the
fitted portafilter.