Need help?Do you have a question about the ANFIM SP- II and is the answer not in the manual?
General| Burr Diameter | 75 mm |
|---|---|
| Grinding Adjustment | Stepless |
| Hopper Capacity | 2 kg |
| Voltage | 220-240 V |
| Frequency | 50/60 Hz |
| Category | Coffee Grinder |
Use for grinding coffee; improper use is unauthorized. Key safety: unplug, no immersion, no children.
The coffee grinder is supplied in a special cardboard package with accessories.
No special tools for operation; store dry, protected, between -10/+40 °C.
Features housing, discs, hopper, controls; ON/OFF switch is emergency stop.
Place on flat, dry surface; connect to power socket via plug, ensuring safety compliance.
Fill hopper, open slide, turn ON/OFF switch; display shows dose selection.
Select one or two cups using T1/L1 or T4/L2, insert porta-filter, and push activation switch to grind.
Access programming mode to change grinding time using specific buttons and sequences.
Press T1 for approx. 10 sec to check and view shot counts for 1 and 2 cups.
Change language, reset warning messages, and reset shot counters via specific button sequences.
Adjust grind fineness by turning the black wheel (5) clockwise (finer) or counter-clockwise (coarser).
The ON/OFF switch (3) immediately stops the coffee grinder in case of emergency.
Disconnect from mains; avoid hazards. Clean regularly with dry cloth or soft brush.
Recommended checks every 6 months for grind setting, disc wear, and worn parts.
All technical interventions must be performed by authorized Anfim personnel or service dealers.
To Next Page
