ANFIM SP- II - Grind Coffee Doses; User Menu and Programming; Changing Grinding Time

2,5
seconds
2,5
seconds
4,5
seconds
4,5
seconds
Default settings
SP-II 220-240V
SP-II 110V
D) Grind coffee doses
Dosing time for one cup: 7g
Dosing time for two cups: 14g
5
5.2 User Menu / Programming Mode – change grinding time
·Push and hold T1 or T4 for approx. 5 sec (Fig. C) until led L1 or L2 are
flashing.
·Select T1 or T2 to change grinding time – Led will flash.
·To increase or decrease time by 1 sec push T2 or T3 accordingly.
Set time will appear on display.
·Press T1 or T4 again change grinding time by 1/10 sec. To increase or
decrease time by 1/10 sec push T2 or T3 accordingly. Set time will
appear on display.
·To save adjusted time and exit, press T1 or T4 accordingly.
Led 1 and 2 will stop flashing. Led of selected dose will light-up.
Grinder is ready for use and display will show 1 or 2 cups.
Led 1 and 2 will stop flashing. Led of selected dose will light-up.
·To exit the Programming Mode, press T1 or T4 twice.
Grinder is ready for use and display will show 1 or 2 cups.
By pushing the Barista Mode switch 7 (Fig. B), it is possible to run the grinder
manually. The same function can be used to dose manually or to run the
grinder in case the electronic controls are down.
·To select dose for one cup, push T1 and L1 control led will light up (Fig. C)
·To select dose for two cups, push T4 for and L2 will light up (Fig. C)
·Insert porta-filter and push against activation switch (10) to start
grinding cycle. If grinding cycle is interrupted, led L1 or L2 will start flashing.
Re-insert porta-filter within approx. 5 sec to continue cycle.
The grinder can also be operated by the touch panel to start the cycle.
To change the user mode, enter into the programming mode and set
time lag from 05.0 sec to 00.0 sec.
·In this case insert porta-filter first and then touch T1 or T4 accordingly to
grind coffee for 1 or 2 cups. Grinder will grind full dose, no interruption
possible.