Angelo Po KN50 User Manual

GB
page 23
INSTALLER SECTION
3. TECHNICAL DATA AND USEFUL INFORMATION ON PUMPS
3.1 Emptying pump (optional)
When installing, pay particular attention to the position of the emptying tube (see fig. 7).
N.B: To empty the tub: turn off the appliance by means of the green 0-1 (see par. 4), pull out
the overflow tube and leave the door open. Then keep button 5 pressed until the tub is completely
empty.
During the wash/rinse cycle, excess water will automatically be drained.
3.2 Pressure increasing pump (optional)
When the dishwasher has not been used for some time, check that the supplementary pressure
increasing pump turns freely.
To do this, operate using a screwdriver in the special slot on the ventilating side of the motor
shaft (see fig. 8).
If the pump is blocked, using a plastic hammer lightly tap the end of the screwdriver inserted
in the slot.
MAX 0,8m
fig
.7
fig. 8
CAUTION: INCORRECT
POSITIONING OF THE TUBE.
CAUTION: CORRECT POSITIONING
OF THE TUBE

Angelo Po KN50 Specifications

General

Brand	Angelo Po
Model	KN50
Category	Dishwasher
Language	English