CLEANING AND MAINTENANCE INSTRUCTIONS FOR YOUR ANIONE CERAMIC DRINKING FOUNTAIN FLOW
The fountain must be cleaned regularly. Cleaning frequency depends on the number of pets using the fountain and the quality of your water.
FILTER
The replacement lter should be replaced approximately every 2 to 4 weeks. You can get replacement lters by purchasing part #1331340 AniOne replacement
lter online at www.fressnapf.com
FOUNTAIN
Disassemble and clean the drinking fountain regularly:
1. Unplug the fountain.
2. Lift up the top cover (Figure 6), disconnect the water pipe from the pump and remove the top cover completely. Place it to one side.
3. Unplug the power cord from the transformer.
4. Pour out remaining water from the bottom bowl.
5. Remove power cord, pump and lter box and put these to one side (Figure 7).
6. Remove the tube from the pump (Figure 8) and remove the lter box (Figure 9).
7. Wash the bottom and top bowls with a solution of warm water and mild soap and rinse well or put them into the dishwasher carefully. Remove the
silicone ring from the top bowl before you put the bowl in the dishwasher.
8. Reassemble for use according to the instructions.
876
9
To Next Page
Loading...