Need help?Do you have a question about the AniOne Flow and is the answer not in the manual?
Rinse the replacement filter thoroughly under cool water before placing it into the bottom bowl.
Connect the new filter to the pump and attach the clear tube to the pump nozzle.
Place assembled pump and filter in bottom bowl, secure suction cups, and thread power cord through the hole.
Align clear tube with water spout and place the top bowl onto the fountain.
Place the fountain in its desired location and use a protective mat to protect the floor.
Fill the unit with approximately 2 litres of water.
Plug the power cord into the adapter.
Allow 1 to 2 minutes for the pump to start pumping after being plugged in.
Add water as needed, keeping the fountain filled to 1.5 cm from the top edge.
Replace the filter approximately every 2 to 4 weeks. Purchase part #1331340 online.
Unplug the fountain, lift the top cover, disconnect the water pipe, and remove the cover.
Unplug transformer, pour out water, remove power cord, pump, and filter box.
Wash bowls with warm water and mild soap or use the dishwasher. Remove silicone ring before washing.
Reassemble the fountain for use according to the instructions provided.
Ensure the motor flow rate lever is set to the maximum or '+' position.
Attach the replacement filter to the pump and connect the clear tube to the pump's water tube.
Place assembled pump/filter in bowl, secure cups, thread cord, and add rubber cover.
Align clear tube with water spout and place the top bowl in position.
Position fountain, use protective mat, and fill with approximately 2 litres of water.
Plug in power cord (ensure hands/cord are dry), allow 1-2 minutes for pump activation.
Fill with water up to the boundary line or 1.5cm below the bowl's upper edge.
Guidance for pets adjusting to the fountain and optimal placement suggestions.
Details on model, power requirements (Pump 5V, Plug 230V), and power consumption (1W).
Follow basic precautions, inspect cord/plug for damage, use only recommended attachments.
Avoid placing near tubs/sinks, unplug when not in use or before cleaning, grasp plug not cord to unplug.
Prevent pets/children chewing parts, avoid self-repairs, handle wet plugs carefully, check for damage.
Supervise children, keep away from packaging material, choking hazard if swallowed.
Protect from extreme temperatures and impacts. Use non-abrasive cleaning products.
Use only the intended power supply. Stop use if damaged or dropped. Seek professional repairs.
Dispose of old devices separately from domestic waste for proper recycling.
General| Brand | AniOne |
|---|---|
| Model | Flow |
| Category | Outdoor Fountain |
| Language | English |
To Next Page