AniOne Flow - Reassembling and Restarting Your Fountain; Set Motor Flow Rate; Attach Filter and Water Tube; Assemble Pump and Bowl (Post-Cleaning)

REASSEMBLING AND RESTARTING YOUR FOUNTAIN AFTER CLEANING
1. Make sure that the motor ow rate lever is set to the maximum or “+” position (Figure 10).
2. Change the replacement lter (please replace any lter over four weeks old). If using a new replacement lter, rst rinse the lter before use.
3. Attach the replacement lter to the pump. Attach the clear tube to the water tube of the pump.
4. Place the assembled pump and lter back inside the bottom bowl and press it down so that the suction cups stick to the bowl (Figure 10). Thread the
pump’s power cord through the cylindrical hole in the bottom bowl and put on the rubber cover.
5. Place your nger on the nozzle of the top cover (Figure 11). Please make sure that the upper end of the clear tube lines up with the water spout of the
top bowl and put the top bowl in position (Figure 12).
6. Place the fountain in its desired location. The use of a protective mat is recommended to protect your oor from splashes or drips which may occur
when in use.
7. Fill the unit with approx. 2 litres of water.
8. Plug the power cord into the adapter. Before you plug in the fountain, make sure both the cord and your hands are dry.
9. Please allow 1 to 2 minutes for the pump to start pumping once plugged in.
10. Add water as needed. It is recommended to ll with water up until the boundary line on the lower rim of the cover and to always keep the fountain
lled with water to 1.5cm below the bowl’s upper edge.
USAGE TIPS
When being introduced to the AniOne Ceramic Drinking Fountain Flow, your pet may be cautious about this new source of water. After putting the
fountain into operation, allow your pet to get used to it at his or her own pace. Some pets take a few days or sometimes a little longer to begin using it.
Your pet may prefer the fountain to be placed away from their normal feeding area. Try plugging it in somewhere else, like the laundry room,
bathroom or another corner of the kitchen.
DO NOT RUN DRY!
SPECIFICATIONS
Model: AniOne drinking fountain Flow
Power requirements: Pump 5 V - Power plug: 230V
Power consumption: 1 W
1210 11