AnkerWork H300 - Bluetooth Connection Issues; Dongle Automatic Connection; Automatic Reconnection to Two Devices

WhatshouldIdoifthedonglecannotconnecttotheheadset
automatically?
1. Turnofftheheadsetandturnitbackon.Unplugandplugthedonglebackin.Changetoa
differentUSB-Aport.
2. CheckiftheheadsetisalreadyconnectedtotwodevicesviaBluetoothorifit'sinwired
mode.YoucandisconnectoneofthedevicesifyouareinBluetoothmultipointpairingmode.
Ifyou'reinwiredmode,removetheAUXcableandpluginthedongle.
3. Ifthedongleindicatorflashesblueslowly,thedongleisinpairingmode.Toconnect,turnon
theheadsetandmoveitclosetothedongle.Toggletheheadset'spowerbuttontothe
Bluetoothpositiontoputtheheadsetinpairingmode.Thedongleandheadsetwillconnect
automatically.
Ifthisdoesnotwork,usetheAnkerWorksoftwaretopairtheheadsetanddongleagain.
WhatshouldIdoifthereisinterferencewhenconnectingvia
dongle?
Donotplugtheheadsetdongleonthesamesideofyourcomputerasotherdongles.Adjustthe
headsetdonglepositiontoavoidinterferencewithotherdongles.
BluetoothConnectionIssues
Whydoestheheadsetnotreconnecttotwodevicesautomatically?
1. Checkiftheheadsetisonandclosetothedeviceyouwanttoconnectto.Reconnectwithin
20secondsofmakingtheseadjustments.
2. Theheadsetcannotreconnectautomaticallyifyou'reonacallorplayingmusic.Enter
pairingmodeandtryagain.
3. Iftheheadsetcan'treconnectautomatically,restarttheheadsetandtryagain.Youmayalso
tryreconnectingthedeviceviatheconnectionhistoryintheAnkerWorkapp.
Ifthisdoesnotwork,forgetthedeviceonyourphoneorcomputer,andthenturnoffBluetooth.
ResettheheadsetbyholdingtheVolume+and-buttonssimultaneouslyfor5seconds.Turn
yourphoneorcomputer'sBluetoothbackonandsearchforAnkerWorkH300.