Note: Never fill with descaler, perfume or detergent into the water tank, this
can damage the appliance.
3. Close the safety lid securely by pushing the lid down and turning it clockwise
until it is fully tight.
4. Put the desired accessory (nozzle, hose, scrubbing brush etc.) on the appliance:
Set the accessory on the connection by matching dot “ ” with unlock symbol”
”and press it up to the rubber sealing. Turn the accessory in the clockwise
direction (follow the direction of symbol” ”), until it meet position of lock
symbol” “.
5. The brush and the curved nozzle:
The brush and the curved nozzle can be assembled on the housing, with the
hose or the straight on the nozzle as shown below.
6. Window wiper:
Warning! Do not operate this appliance directly on cold glass.
The window wiper must be attached to the scrubbing brush. Assemble the
scrubbing brush on the appliance or the hose at first. Take off the cloth from
the scrubbing brush and connect the window wiper to the brush by the two
hinges (refer figure below). The window wiper can be dismantled easily by
loosening the hinges again.
Operation:
7. Attach the appliance to the mains power supply and the control lamp should
lights up. The appliance will take approximately 3 to 4 minutes to pre-heat and
the control lamp should go out. Make sure not to disconnect appliance from
mains power or press the steam button during the preheating process.
When the control lamp goes OFF the steamer is ready for use. Press the
steam button and move it slowly over the surface which is to be cleaned. It is
recommended that the distance between the nozzle and the surface around to
2-3cm minimum.
To Next Page
Loading...
Need help?
General
