anko QL-5915A - Product Information; Introduction and Usage; Parts Identification; Initial Setup Steps

INTRODUCTION
Use this appliance to dry human hair only. Do not use this appliance on artificial hair or
animals. The appliance may have different results depending on the hair type. Therefore, we
recommend to do a trial at a hidden spot before first use. The hairdryer is not recommended
for damaged or bleached hair.
PARTS
1. Air outlet
2. Rear grille/Air inlet
3. Cool Shot Switch
4. Fan speed switch
5. Foldable Handle
6. Voltage selector
7. hanging loop
8. concentrator
BEFORE FIRST USE
• After unpacking the appliance, check for transport damage and that all the parts
mentioned in this manual are present. In the event of damaged or missing parts, return
the product back to Kmart.
• Do not discard the original box. It can be used for storage and dispatch to avoid
transport damage.
• Clean the appliance as described in CLEANING AND MAINTENANCE. For your safety
make particular attention to the IMPORTANT SAFEGUARDS supplied in the user
manual.
• For Australia the Voltage Selector (6) must be set to 220-240V AC.
1
3
4
2
5
7
8
6