Electrical Safety
3
ELECTRIC SHOCK HAZARD. The construction of this control enclosure poses potential
exposure to alternating current and direct current which has the potential to cause injury
or death. This equipment should be constructed and serviced by trained or qualified
persons.
Keep the area around the device clear and free from dust before, during, and after
installation.
Wear safety glasses if you are working under any conditions that could be hazardous to
your eyes.
Do not perform any actions that create a potential hazard to people or make the
equipment unsafe.
Never install or manipulate wiring during electrical storms.
Never install electrical jacks in wet locations unless the jacks are specifically designed for
wet environments.
Operate the device only when it is properly grounded.
Ensure that the separate protective earthing terminal provided on this device is permanently
connected to earth.
Replace fuses only with fuses of the same type and rating.
Do not open or remove chassis covers or sheet-metal parts unless instructions are
provided in the hardware documentation for this device. Such an action could cause severe
electrical shock.
Do not push or force any objects through any opening in the chassis frame. Such an action
could result in electrical shock or fire.
Avoid spilling liquid onto the chassis or onto any device component. Such an action could
cause electrical shock or damage the device.
Avoid touching uninsulated electrical wires or terminals that have not been disconnected
from their power source. Such an action could cause electrical shock.
Always ensure that all modules, power supplies, and cover panels are fully inserted and that
the installation screws are fully tightened.
To Next Page
Loading...