To Next Page
A
Alejandro ThompsonJul 28, 2025
Why is my Annovi Reverberi Blue Clean 575 - 585 - 595 Pressure Washer pump not reaching working pressure?
- NNatalie HendersonJul 28, 2025
If your Annovi Reverberi Pressure Washer's pump isn't reaching working pressure, several factors could be the cause. The nozzle might be worn and require replacement. The water filter might be clogged, so you should clean it. The water supply pressure could be too low, so ensure the water supply tap is fully open. Air might be getting sucked into the system; in this case, check the tightness of hose fittings. There might be air in the pump; to resolve this, switch off the appliance and repeatedly depress and release the gun trigger until the water flows steadily, then switch the appliance back on. Finally, the adjustable nozzle might not be positioned correctly; adjust it accordingly.
General
