What to do if my Annovi Reverberi Pressure Washer engine will not start?
- CCraig KimJul 31, 2025
If your Annovi Reverberi Pressure Washer engine won't start, there are several things you can check: * Ensure the fuel shutoff valve (if equipped) is in the ON position. * Add fuel if the pressure washer is out of fuel. * Inspect and clean fuel delivery passages if the fuel flow is obstructed. * Push the primer bulb three times to prime the unit. * Check and clean the air filter. * Check the oil level and add oil if necessary. * Firmly push down on the spark plug boot to ensure it's fully engaged. * Remove and check the spark plug, replacing it if faulty. * Drain stale fuel and replace it with fresh fuel. Also, drain and replace the fuel if there's water in it.