SETTING UP
fill a pot
• Fill a pot or container with water.
• Place it on a heat-safe surface or trivet, away from counter edges.
attach your cooker
• Loosen the rear screw on your Anova Precision® Cooker clamp.
• Fit the clamp over the edge of your pot or container.
• Tighten the rear screw so it is snug against the wall of the pot.
• Adjust the height* of the cooker by adjusting the side screw.
(do not overtighten screws)
*Only applicable to the Anova Precision
®
Cooker 3.0.
plug in
• Plug in your Anova Precision® Cooker.
• Place your food in a sealable bag and lower the bag into the water.
• Clip the bag to the side of the pot. (optional)
Precision Cooker QSG Master_EN_FR-CA.indd 4Precision Cooker QSG Master_EN_FR-CA.indd 4 15/12/2022 3:50:50 PM15/12/2022 3:50:50 PM
To Next Page
Loading...
