Anritsu Site Master S332D - Chapter 2 Functions and Operations; SYS

SYS
In cable and antenna analyzer or optional power meter mode, pressing the SYS
key displays the following System menu soft key selections:
q
Options — Displays a second level of functions:
q
Units — Select the unit of measurement (metric or English).
q
Printer — Displays a menu of supported printers. Use the Up/Down arrow
key and ENTER key to make the selection.
q
CAL Mode — In cable and antenna analyzer modes, selects either OSL
Cal or FlexCalä. FlexCal is a broadband frequency calibration valid from
25 MHz to 4 GHz. Refer to Calibration, page 3-2, for more information.
q
Change Date Format — Toggles the date format between
MM/DD/YYYY, DD/MM/YYYY, and YYYY/MM/DD.
q
Back — Returns to the top-level SYS Menu.
q
Clock — Displays a second level of functions:
q
Hour — Enter the hour (0-23) using the Up/Down arrow key or the key
-
pad. Press ENTER when data entry is complete or ESCAPE to restore
the previous value.
q
Minute — Enter the minute (0-59) using the Up/Down arrow key or the
keypad. Press ENTER when data entry is complete or ESCAPE to re
-
store the previous value.
q
Month — Enter the month (1-12) using the Up/Down arrow key or the
keypad. Press ENTER when data entry is complete or ESCAPE to re-
store the previous value.
q
Day — Enter the day using the Up/Down arrow key or the keypad. Press
ENTER when data entry is complete or ESCAPE to restore the previous
value.
q
Year — Enter the year (2003-2036) using the Up/Down arrow key or the
keypad. Press ENTER when data entry is complete or ESCAPE to re-
store the previous value.
q
Back — Returns to the top-level SYS menu.
q
Self Test — Start an instrument self test.
q
Status — In cable and antenna analyzer freq or dist measurement mode, dis
-
plays the current instrument status, including calibration status, temperature,
and battery charge state. Press ESCAPE to return to operation.
q
Language — Pressing this soft key immediately changes the language used to
display messages on the Site Master status window. Choices are English,
French, German, Spanish, Chinese, and Japanese. The default language is
English.
In Spectrum Analyzer mode, pressing the SYS key displays the following Sys
-
tem menu soft key selections:
q
Options — Displays a second level of functions:
q
Printer — Displays a menu of supported printers. Use the Up/Down arrow
key and ENTER key to make the selection.
q
Change Date Format — Toggles the date format between
MM/DD/YYYY, DD/MM/YYYY, and YYYY/MM/DD.
Chapter 2 Functions and Operations
2-29