Anritsu Site Master S332D - Chapter 1 General Information; Printers; Optional Accessories

Adjusting Markers .............................3-15
Adjusting Limits ..............................3-16
Adjusting the Display Contrast .......................3-17
Adjusting the Backlight Intensity......................3-17
Printing ....................................3-18
Using the Soft Carrying Case.........................3-19
Chapter 4 - Cable and Antenna Analyzer Measurements
Introduction ..................................4-1
Line Sweep Fundamentals ...........................4-1
CW Mode ..................................4-2
Information Required for a Line Sweep ...................4-3
Typical Line Sweep Test Procedures ....................4-3
Chapter 5 - Spectrum Analyzer Measurements
Introduction ..................................5-1
Measurement Fundamentals ..........................5-1
Preamplifier ..................................5-3
Preamplifier Operation............................5-3
Preamplifier Measurement Example.....................5-4
Dynamic Attenuation Control .........................5-6
Frequency Converter Interface (Option 6)...................5-7
Introduction .................................5-7
Bias Tee (Option 10)..............................5-7
Introduction .................................5-7
Selecting the Signal Standard and Channel ..................5-8
Field Strength Measurements ........................5-9
Occupied Bandwidth .............................5-10
Channel Power Measurement........................5-12
Adjacent Channel Power Ratio .......................5-14
Interference Analysis .............................5-16
AM/FM Demodulation ............................5-17
Demodulation Procedure ..........................5-17
Carrier to Interference Ratio (C/I) ......................5-19
Procedure ..................................5-19
Chapter 6 - Power Measurement
Introduction ..................................6-1
Power Measurement ..............................6-1
Chapter 7 - T1 Measurements
Introduction ..................................7-1
T1 Fundamentals................................7-1
Network Equipment ..............................7-2
Testing T1 Circuits...............................7-3
In Service Testing ..............................7-3
Out-Of-Service Testing ...........................7-6
ii