Manual Revision Code: FRONTLINE-SRL-04 10-19-20
11
iniate the requirement for inspecby a competent person.
(2) Failure of a competent person to perform inspecns as specid in this Table, or failure of an
inspecn by the competent person shall iniate product revalidaor disposal.
(3) Determinaof the type of use category shall be determined by a competent person.
(4) An SRL that is considered non-repairable, or not designed for disassembly such that internal inspec
is not possible without rendering i
t unserviceable, is not subject to revalid
※These SRL's shall have service life and other inspecn requirements as provided by the manufacturer’s
instrucns.
Component: Inspecon: User Competent
Person
Inspect for loose or missing fasteners or damaged parts
Inspect the housing for distorn, cracks, or damage
Inspect the Harness Interface for distorn, cracks
The Interface should pivot freely.
The Lifeline should pull out and retract fully without
hesitan or creang a slack line cn.
Ensure the SRL locks up when the lifeline is jerked
sharply.
Lockup should be posive with no slipping.
All labels must be present and fully legible.
Inspect the enre SRL for signs of corrosion.
Lifeline Inspect the lifeline wire rope for cuts, kinks, broken
wires, bird-caging, corrosion, welding splaer, chemical
contact areas, or severely abraded areas.
Slide up Cable Guide Bumper and inspect ferrules for
cracks or damage. The lifeline must be free of knots
throughout its length.
Interface
Inspect the Locking pin to ensure it is securely closed and
locked around the harness shoulder straps.
Lanyard End
Connectors
Inspect Snap hook for signs of damage, corrosion, and
proper working cn.
Where present: Swivels should rotate freely and gates
should open, close, lock and unlock properly.
To Next Page
Loading...
Need help?
General
