Why does the heater element glow in my Anslut 013517?
The heater element in your Anslut Heater might be glowing because: * The input voltage is either too high or too low. Try plugging it into a power point with the correct voltage, as indicated on the rating plate of the product. * The air inlet is blocked. Make sure to place the heater away from curtains, plastic bags, paper, and other objects that could block the airflow.
What to do if my Anslut 013517 does not get hot, and only the fan is working?
If your Anslut Heater's fan is working but not the heat, there might be a few reasons: * Ensure the power dial is set to a heating mode. * The thermostat may have disconnected the heating element. Try turning the temperature dial and listen for a clicking noise. If there's no click and the thermostat is fine, the heating element should turn on once the temperature drops. * The overheating protection may have tripped. Turn off the heater, check for any blockages in the air inlet or outlet, unplug it, wait 10 minutes for it to reset, and then try again.
Why won't my Anslut 013517 start even when plugged in and set to maximum?
If your Anslut Heater isn't starting, even when plugged in and set to maximum, it could be due to: * A broken or loose wire, or loose contact in the plug or power point. Unplug the heater and check for loose connections. If necessary, replace the plug and try again. * The power point may not be providing voltage. Try plugging the heater into another power point.
How to stop abnormal noise from my Anslut Heater?
If your Anslut Heater is making abnormal noise, it might not be standing on a level surface. Place the heater on a level and stable surface.
Important! Read the user instructions carefully before use. Save them for future reference.
Covers general safety rules, warnings about hot parts, and fire risks.
Explanation of the symbols used in the manual.
Identifies and describes the controls and indicators on the heater.
Details the intended use and step-by-step instructions for operating the heater.
Explains the overheating protection feature and provides cleaning and maintenance guidance.
General| Power | 2000 W |
|---|---|
| IP Class | IP20 |
| Frequency | 50 Hz |
| Adjustable Thermostat | Yes |
| Overheat Protection | Yes |
| Tip-Over Protection | Yes |
| Oscillation | Yes |
| Remote Control | No |
| Timer | No |
To Next Page
