ANSMANN Comfort Mini - Troubleshooting, Care, and Data; Troubleshooting; Care and Maintenance; Technical Data

14
Deutsch | English | Français | Español | Português | Svenska
Italiano | Nederlands | Dansk | Suomi | Norsk
(*1) If the connected USB device does not supply enough current (recommended
min. 1A), the device will pause a charging slot. You can still charge your batteries
without any problems, but the charging process takes longer due to this pause.
TROUBLESHOOTING
Problem Possible cause Resolution
No LED indication - No connection to
USB power source
- USB power supply
defective
- Check the con-
nection
- Use a different
USB power supply
Battery is not recog-
nized
- Battery inserted
with reverse
polarity
- Insert the battery
with the correct
polarity
LED is flashing orange - Battery slot pau-
ses, as the current
of the USB power
source is too low to
charge all batteries
at the same time
- Use USB power
source with a mini-
mum of 1A output
current
- Or accept the lon-
ger charging time
CARE AND MAINTENANCE
Cleaning
Disconnect the power supply to the product and remove all batteries
before cleaning.
Only use a soft, dry or slightly damp cloth for cleaning (if necessary,
add a little mild washing-up liquid). Never use abrasives or solvents for
cleaning.
TECHNICAL DATA
Power source USB 5V, min. 1A for fastest charging, max. 2.4A
Charging slots 2
Charge current AA: 800mA / AAA: 400mA
Trickle charge current AA: 13mA / AAA: 6.5mA