rechargeable batteries at the same time, the charging current can be
set to 400mA, 600mA or 800mA. Using the programs “DISCHARGE”
and “REFRESH” discharging currents of 200mA, 300mA or 400mA can
be selected. The charging current is generally twice as high as the
chosen discharging current.
ATTENTION: Please ensure that the rechargeable batteries are desi-
gned for the respective charging current. For example, AAA rechar-
geable batteries should not be charged with a 1500mA or 1800mA
charging current! We recommend choosing the maximum charging
current (mA) so that it does not exceed the capacity value (mAh) of
the inserted rechargeable battery.
It is normal that batteries may become warm during charging. After
charging is complete, the charger switches automatically to trickle
charge. The trickle charge prevents self discharge of the batteries
when left in the charger.
LCD DISPLAY
“- --“ is shown when there is no rechargeable battery inserted but the
charger is connected to mains. “- -- mAh“ is shown during the first
charging cycle when in “TEST” mode.
“Full“ is shown when the charging process is finished and the char-
ger switches to trickle charging. After finishing the charging program
“TEST”, the display switches between “Full“ and the measured di-
scharging capacity in mAh/Ah.
“0 00“ flashes when a rechargeable battery is defective or a non
rechargeable battery is inserted e.g. alkalines.
During the charging process the preset parameters are displayed as
mentioned under point 3 (DISPLAY). In addition, the chosen charging
program and the current process (CHARGE or DISCHARGE) are shown.
In the illustration [3] you can see an example of the LCD display. This
example shows 4 different display modes and 4 different charging
programs.
ENVIRONMENT
Do not dispose of the device in the normal household waste. Please
return it to your dealer, nearest recycling centre or collection point.
Please also recycle all packing materials.
CARE & MAINTENANCE
To make sure that the charger works properly, please keep the con-
tacts in the charging slots free from dirt and dust. To clean the unit
disconnect it from the mains and only use a dry cloth.
TECHNICAL DATA
Input voltage external power supply: 100-240V AC / 50-60Hz
Input voltage charger: 12V DC
Charging current range: 400mA – 1800mA
Maximum charging capacity: 3000mAh
USB-charging socket: 5V / 1000mA
DISCLAIMER
Information in these operating instructions can be changed without
prior notice. ANSMANN cannot accept liability for direct, indirect,
accidental or other claims by not using this device as indicated by
these operating instructions. Consequential losses are not accepted
at any time.
WARRANTY NOTICE
We hereby offer a 3 year warranty on this charger. This does not apply
to damages caused by: low quality batteries leaking inside the char-
To Next Page
Loading...
Need help?
General
