Ansul AUTOPULSE IQ-396X - Intelligent Detector Functions; Detector Settings and Operation Management

14 AUTOPULSE IQ-396X Programming Doc. 50402:B 07/22/96
Programming a Point, continued
NAC/Panel Output Circuit
Type Codes
Type Code selections for NAC/Panel Output Circuits follow:
NAC/Panel Output Circuit Type Codes
edoCepyTnoitcnuFlaicepS
lortnoCCANdesivrepuS
yaleRtuptuoyaleR
tiucriClleBCANdesivrepuS
tkCebortSCANdesivrepuS
tiucriCnroHCANdesivrepuS
tkCelbiduACANdesivrepuS
rekaepSCANdesivrepuS
lleBdnEleRCANdesivrepuS
lebalknalbedoCepyTrehtoonnehwesu(CANdesivrepuS
)seilppa
tkCesaeleRrofdesivrepus,detimilrewopnon,tiucriCgnisaeleR
stluafdnuorgdna,strohs,snepo
CLUtkCleR,sneporofdesivrepus,detimilrewop,tiucriCgnisaeleR
stluafdnuorgdna,strohs
CmroF.aeleResaelernopuetarepostcatnoc,tuptuoyaleR
elbiduAleResaelernopudetavitca,CAN
enohpeleTtiucricenohpeletdradnatS
lleBedoCleR)ylnoCAN004-SPM(CANdesivrepuS
The table of Type Codes contains
a comprehensive list of Type
Codes. The Type Codes that
display, however, depend on the
type of circuit.
Autoprogram selects the following default system functions the first
time you program the control panel. System defaults do not appear on
the display. Subsequent Autoprogramming will not change previous
editing of these functions. The following table contains a list of the
default functions and values.
System Defaults
System Defaults
snoitcnuFseulaVtluafeD
00enoZenoZmralAlareneG=lebalmotsuC
98hguorht10senoZknalbsilebalmotsuC
0FN=SAP;081=yaleD;yaleDSAP/langiserP=lebaL
9R-0RlortnoCesaeleRtcnuFesaeleR=lebaL
;ILU=TROBA
;N=SSORC
;0000=KAOS
A/N
6Fdna5FlortnoCemiTnoitcnuFemiT=lebaL
HSFTWTMS=syaD;00:00=ffO
7F00/00erasyadlla;tcnuFyadiloH=lebaL
8FemiThcraM=epyTedoC=lebaL
9Ffo%07=trelA;tcnuFmralA-erP=lebaL
mralafo%00=noitcA;mrala
sretemaraPmetsyS;51=YFIREV;000=OTUA;000=HNILIS
;TmeR;VPUSNON=NUNNA;EMITASU
N=SPVA;4=TS;Y=KNILB
sdrowssaP1111=egnahCsutatS,00000=egnahCmargorP
lamroNsmetsySllAA/N
egasseMmotsuCsknalb04
For details on programming
special zones F0-F9 and R0-R9,
refer to Special Zone Change.
For details on programming
system parameters, refer to
System Function Program-
ming.