Ansul AUTOPULSE IQ-396X - Pre-Alarm Operation (AWACS)

AUTOPULSE IQ-396X Programming Doc. 50402:B 07/22/96 15
Changing a Password
The Message option lets you change the 40-character All Systems
Normal message. From the Program Change screen, press <4>.
The control panel displays the Message Change screen:
Message Change screen
Changing a Password
To change a password, follow the instructions in the following table:
How to Change a Password
Password Change lets you customize a high-level or low-level pass-
word. From the Program Change screen, press <3> to display the
Change Password screen, then follow the instructions in the table.
Change Password screen
SYS NORMAL MESSAGE
Message change area
1) Change one character at a time, indicated by the blinking cursor
on the second line of the display.
2) Enter up to 40 characters maximum.
3) Enter lower case and special characters by pressing and holding
the <Lower Case> key then typing the character.
CHANGE PASSWORD *,NNNNN,E=PROGRAM
#,NNNNN, E=STATUS
Display area for
new password.
3
0=CLR 1=AUTO 2=POINT 3=PASSWD 4=MESSAGE
5=ZONES 6=SPL FUNCT 7=SYSTEM 8=CHECK PRG
0=CLR 1=AUTO 2=POINT 3=PASSWD 4=MESSAGE
5=ZONES 6=SPL FUNCT 7=SYSTEM 8=CHECK PRG
4
Changing the System
Message
Blinking cursor
How to change the System
Message
...oTsserP...neht
ehtegnahC
drowssapmargorP
H
wenehtepyt
.drowssapmargorP
sutatSehtegnahC
drowssap
I
sutatSwenehtepyt
.drowssap
drowssapehtevaS
C
egnahCdrowssaPeht
.sraeppaneercs
tideehtevaeL
tuohtiwneercs
agnignahc
d
>ecapskcaB<egnahCdrowssaPeht
.sraeppaneercs
...oTsihtoD
retcarahcgniknilbaegnahCehtmorfretcarahcaepyT
dapyek
retcarahctxenehtotevoM
sserP
G
egassemwenehtevaS
sserP
C