Ansul AUTOPULSE IQ-396X - Read History Functions; History File Overview and Access Methods

20 AUTOPULSE IQ-396X Programming Doc. 50402:B 07/22/96
0=CLR 1=AUTO 2=POINT 3=PASSWD 4=MESSAGE
5=ZONES 6=SPL FUNCT 7=SYSTEM 8=CHECK PRG
System Function
Programming
ACS Selection Groups
The following screen shows an example of ACS Selection Groups.
This example shows annunciator selections for addresses A1-A3 (ad-
dresses A4-A10 not selected) and addresses A11A19 set to send panel
status to a UDACT.
 Annunciators set to Address 1 display the status of detectors 1-64
(ACS Selection Group 6) on SLC loop 1;
 Annunciators set to Address 2 display the status of detectors 1-64
(ACS Selection Group 7) on SLC loop 2; and
 Annunciators set to Address 3 display the status of the NAC/Panel
Output Circuit modules (ACS Selection Group 9).
8
Check
Display After Successful Program Check
When finished programming, use the Check option to search the pro-
gram entries for possible errors. From the Program Change screen,
select <8>. The Check option searches the program for the following
conditions:
 Output points mapped to a zone without a mapped input.
 A zone with mapped input points without mapped output points
(including Z00 outputs).
 Releasing zone inputs (R0-R9) with no RELEASE CKT outputs mapped
to them; or RELEASE CKT outputs with no R0-R9 inputs mapped to
them.
 RO-R9 inputs not mapped to MAN RELEASE.
If the Check option detects multiple devices that fail the check, press the
Previous or Next keys to step through the devices. If you get errors,
return to Point Programming and correct the errors.
Annunciator Selection Screen Example
SCA
noitceleS
puorG
yalpsiDrotaicnunnA
165-1senoZdnasutatSUPC
2
laicepS61dna4-1stkCCAN,99ot75senoZ
senoZ
3461ot101seludoMtnegilletnI
4462ot102seludoMtnegilletnI
5
ot562dna691ot561seludoMtnegilletnI
692
61poolCLSno461ot101srotceteD
72poolCLSno462ot102srotceteD
8692ot562dna691ot561srotceteD
9
46(seludoMtiucriCtuptuOlenaP/CAN
)stniop
0ro*sserddAtAdellatsnItoNrotaicnunnA
Program Check OK.
RE-TEST PANEL NOW 09:50A Fri 08/04/95
ANNUN SELECTION1 A1=6 A2=7 A3=9 A4=*
A5=* A6=* A7=* A8=* A9=* A10=* UDACT=Y
If UDACT=N, you can use
addresses A11A19 on Annuncia-
tor Selection 2 Screen to select
annunciators.
The control panels annunciation points are divided into nine ACS
selection groups of 64 points, listed in the following table. Refer to
Appendix A in the Installation Manual for a list of the 64 points within
the ACS Selection Groups.
For detailed information on
annunciators, refer to Appendix A,
Annunciators, in the IQ-396X
Installation Manual (Document
50401).