Ansul AUTOPULSE IQ-396X - Reading Specific Point and Zone Status

AUTOPULSE IQ-396X Operations Doc. 50403:B 07/22/96 13
Read Status
Read Status for a Detector, Module, or Output
From the Read Status screen, press <0>; then press <Enter>. You can then
read the status of a detector, module, or output. For example, to read the
status of a detector at D101, press H, enter the address (D101), then press
<Enter>. The control panel displays information about the detector as
shown in Figure 21:
Refer to the IQ-396X Program-
ming Manual for information on
Alarm and Pre-Alarm sensitivity.
dleiFnoitpircseD
)OTOHP(EKOMSrotcetedehtfoedocepyT
101RDDAROTCETED )10sserdda=10;1pool=1(101:lebalmotsuctluafeD
30Z:noitcelesenoztluafeD
)srotcetedtaeH(10enoZ
)srotcetednoI(20enoZ
)srotcetedotohP(30enoZ
)srotcetedresaL(40enoZ
)srotceteditluM(50enoZ
hcaerofsenozeromruofddasallewsasenozegnahcnacuoY
.EBCsrotceted
5:LA 1dnaevitisnestsaeleht9htiw,levelytivitisnesmralaehT
.evitisnestsomeht
0:AP dna0neewtebrebmunagnitteslevelmralA-erPehtswohS
:swollofsa9
mralA-erPon0
evitisnestsaeleht9htiw,levelytivitisnesmrala-erPehT
.evitisnestsomeht1dna
rotceteditluM )ffo=*(:gnittesrotceteditlumehtsetacidni)*(ksiretsatsrifehT
sinoisicedmralas'rotcetedehtA
.evobasserddatxenehthtiwdenibmoc
.wolebsserddatxenehtsesuB
txenehtfonoitanibmocehtsesuC
.sserddatsehgihtxenehtdnatsewol
noitacifreVmralA gnittesnoitacifireVmralAehtsetaccidni)*(ksiretsadnocesehT
.)ffo=*;n0=V(
Read Status for a Zone Address
From the Read Point screen, press z, then enter the zone address (01-99)
Figure 23 shows the default Read Status display for a zone:
OFF SOFTWARE ZONE FLOOR 5 MAIN BLDG
Z04
Zone status (ON or OFF)
Zone number
Figure 22: Default Read Status Values for a Detector
Figure 21: Detector Read Status Sample Screen
NORMAL SMOKE (PHOTO) DETECTOR ADDR 101
Z03 Z Z Z Z 000%A5 PA:0 ** D101
Alarm Verification
Multidetector
Read Status for Points and
Zones
Figure 23: Read Status Display for a Zones Address
 Press L to read a point or zone
with next highest address; or
 Press M to read a point or
zone with next lowest address.