6
FT-20S Power Base (Optional)
Setting Up
DO NOT CHARGE THE BATTERY WHILE MAKING FOG OR SWITCH IS ON
Step 1: Place the machine on a flat surface and in a suitably large area with at least 50 cm
of open space around the machine.
Step 2: Fill the fluid tank with Antari FLM-05W fluid.
Step 3: Please fully charge the battery upon receipt of the machine and before and after
each operation. The head unit should be seperated while charging.Charge the battery by
plugging the charger adaptor into a grounded electrical outlet. Yellow light on the adaptor
indicates charging, when it turns green then the charge complete. Please note the battery
requires 3 hours charge time. A fully charged battery can run the machine for roughly 12
minutes.
To Next Page
Loading...
