2019.10.25
TP, rev13
Side 1 af 4
Smart Connect Mini user manual
Compliance statement Smart Connect Mini and Smart Eye Mini
Smart Connect Mini
Contains FCC ID XMR201707BG96
Contains FCC ID 2AOFP-E0048
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Smart Eye Mini
Contains FCC ID 2AOFP-E0048
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
if the FCC identification number is not visible when the module is installed inside another
device, then the outside of the device into which the module is installed must also display a
label referring to the enclosed module, Contains FCC ID: 2AOFP-E0048.
Information to user
if the FCC identification number is not visible when the module is installed inside another
device, then the outside of the device into which the module is installed must also display a
label referring to the enclosed module, Contains FCC ID: 2AOFP-E0048.
Caution: any changes or modifications not expressly approved by Anticimex Innovation Center
A/S will void the user’s authority to operate the equipment.
This equipment has been tested using a shielded network cable (STP). The Smart Connect Mini
and Smart Eye Mini are only in compliance if no changes or modifications is made to the device
The Smart Connect Mini and Smart Eye Mini are in compliance with the requirement for RF
exposure in US with 20 cm separation distance between the user and/or bystander of the
device.
The latest version of the manuals and datasheets are always available on
anticimexonline.sharepoint.com
The antenna is fixed to the device and no change in antenna or fixation of the antenna is
acceptable and such modification is considered to violate the Compliance Statement
To Next Page
Need help?
General
